Improvement of The Gradation of Basic Soil Grains With The Addition of Cement and Clay Soil Against Cbr Values (Hukurila-Seri Ring Road Case Study)

Authors

  • SM. Andika Para Program Studi Teknik Sipil, Fakultas Teknik Universitas Pattimura, Indonesia
  • Abraham Kalalimbong Program Studi Teknik Sipil, Fakultas Teknik Universitas Pattimura, Indonesia
  • Mansye Ronal Ayal Program Studi Teknik Sipil, Fakultas Teknik Universitas Pattimura, Indonesia

DOI:

https://doi.org/10.51601/ijse.v6i2.512

Abstract

The condition of the subgrade soil on the Hukurila-Seri Ring Road section, Ambon City has the potential to experience a decrease in carrying capacity due to the abandonment of construction projects. To overcome these problems, efforts are made to improve the soil using the stabilization method using additional materials in the form of cement and clay soil. This study aims to determine the classification of soil at the location, as well as evaluate the effect of the addition of cement and clay soil on soil grain gradation and CBR (California Bearing Ratio) value. The test was carried out in the laboratory using native soil taken from the research site, then mixed with variations of cement (4%, 7%, and 10%) as well as a combination of optimum cement + clay soil (2%, 9%, and 24%). The results of the study showed that the addition of cement significantly increased the CBR value of the soil. The optimum mixture is obtained at the 10% cement variation which provides the highest increase in CBR value.

Downloads

Download data is not yet available.

References

[1]. American Society for Testing and Materials. 1971. Standard Test Method of Test for Plastic Limit of Soil. ASTM designation: D 424-74. Philadelphia. PA.

[2]. American Society for Testing and Materials. 1972. Standard Test Method of Test for Liquid Limit of Soil. ASTM designation: D 423-66. Philadelphia. PA.

[3]. American Society for Testing and Materials. 1989. Standard Test Method for Laboratory Determination of Water (Moisture) Content of Soil and Rock by Mass. ASTM designation: D 2216-71. Philadelphia. PA.

[4]. American Society for Testing and Materials. 1989. Standard Test Method for Laboratory Compaction Characteristics of Soil Using Standard Efford. ASTM designation: D 698-70. Philadelphia. PA.

[5]. American Society for Testing and Materials. 2002. Standard Test Method for Specific Gravity of Soil Solids by Water Pycnometer. ASTM designation: D 854-72. Philadelphia. PA.

[6]. American Society for Testing and Materials. 2002. Standard Test Method for CBR (California Bearing Ratio) of Laboratory-Compacted Soils. ASTM designation: D 1883-73. Philadelphia. PA.

[7]. American Society for Testing and Materials. 2007. Standard Test Method for Particle-Size Analysis of Soil. ASTM designation: D 422-72. Philadelphia. PA.

[8]. Ayal, M. R. (2023). The Effect of the Addition of Mountain Sand on the Value of Clay Soil Cbr on the Taeno Upper Road Section in Ambon City. Journal of Symmetry, 13(1), 704-710.

[9]. Budiman, A. A., Pramana, N. J., & Budi, G. S. (2020). Stabilization of the sandy soil using cement and sludge produced by spun pile. Journal of Primary Dimensions of Civil Engineering, 9(2), 23-29.

[10]. Christiady, H. 1992. Soil Mechanics I. Yogyakarta: Gadjah Mada University Press.

[11]. Christiady, H. 1996. Soil Mechanics and Foundation Engineering. Yogyakarta: Gadjah Mada University Press.

[12]. Hakam, A. (2010). The addition of clay to increase the cbr value of Padang sand soil. Journal of Civil Engineering, 6(2), 1-6.

[13]. Hapsari, N. L. K., & Wardani, S. B. E. (2019). Women Candidates in Indonesia: Experience in Candidate Selection within Political Parties.

[14]. Hardiyatmo, H.C. 2006. Soil Mechanics II. Yogyakarta: Gadjah Mada University Press.

[15]. Hendra, H. (2022). Stabilization of Clay Soil with Sea Sand and Fly Ash on CBR Value (Doctoral dissertation, Universitas_Muhammadiyah_Mataram).

[16]. Husnah, H. (2019). Stabilization of clay soil with a mixture of cement and fly ash. Racic: Rab Construction Research, 4(1), 32-41.

[17]. Mina, E., Kusuma, R. I., & Sausan, Z. I. (2021). The Utilization of Slag Cement as a Soil Stabilization Mixture and Its Effect on the Submerged CBR Value (Soaked California Bearing Ratio). Journal of Civil Engineering, 28(3), 261-268.

[18]. Soraya, W., Kalalimbong, A., & Ayal, M. R. (2023). Soil stabilization using mountain sand (Case Study: Atas-Waipoot Taeno Road, Ambon City). Journal of Civil Engineering, 6(1), 169-180.

[19]. Saputra, I. (2021). Stabilization of clay soil with a mixture of ash tires and cement on the value of CBR (Doctoral dissertation, Islamic University of Riau).

[20]. Utami, R. A. A. A. (2021). Stabilization of clay soil using the addition of sand and lime to the value of Cbr.

Downloads

Published

2026-06-07

How to Cite

SM. Andika Para, Abraham Kalalimbong, & Mansye Ronal Ayal. (2026). Improvement of The Gradation of Basic Soil Grains With The Addition of Cement and Clay Soil Against Cbr Values (Hukurila-Seri Ring Road Case Study). International Journal of Science and Environment (IJSE), 6(2), 440–444. https://doi.org/10.51601/ijse.v6i2.512

Issue

Section

Articles